Robot Pi Shop

KY-019 1 Channel 5V Relay Module

$1.35
Quantity
Pickup available at Robot Pi Shop

KY-019 Relay Module is used to control AC circuits, the relay acts as a switch that responds to a signal received from the Arduino, it has an integrated LED that indicates if the signal is high or low.  

Commonly used in IoT projects to control lights and other electronic appliances, compatible with Arduino, Raspberry Pi, ESP32 and other microcontrollers.

KY-019 Specifications

The KY-019 consist of a 1MΩ resistor, a LED, a 1N4007 rectifier diode and a 5VDC relay capable of handling up to 250VAC and 10A.

On the DC side of the board there are 3 male header pins for signal, power and ground. On the AC side there are 3 contacts, NC (Normally Closed),  Common and NO (Normally Open).

Maximum AC 10A 250VAC
Maximum DC 10A 30VDC
Contact Type NC and NO
Board Dimensions 27mm x 34mm [1.063in x 1.338in]

Connection Diagram

For the DC part of the circuit connect S (signal) to pin 10 on the Arduino, also connect the Power line (+) and ground (-) to +5 and GND respectively.

On the AC side connect your feed to Common (middle contact) and use NC or NO according to your needs.

NO (Normally Open) will get power when (S) is high, NC (Normally Closed) gets disconnected when (S) is high.

Always be very careful when experimenting with AC, electrical shock can result in serious injures.

KY-019 Arduino AC Device
S Pin 10
+ +5V
– GND
NC
Common Feed In
NO Feed Out
KY-019 1 Channel 5V Relay Module

Default Title

  • Robot Pi Shop

    Pickup available,usually ready in 1 hour

    Ground Floor Shop, Sayde Street, Fanar Matn 1202
    Fanar
    Lebanon

    +96171791287

You may also like