Robot Pi Shop

NFC Relay Control Modules

$22.99
Quantity

Features:

  • Compatible with DC10V-120V voltage range;
  • Three verification methods: fingerprint, IC card, mobile phone NFC
  • Three control modes can be switched: jog mode, self-locking mode, ignition mode;
  • In the jog mode, the output time can be adjusted, and the output can be up to 15 minutes;
  • With relay normally open and normally closed output control.
  • IC card/NFC sensing distance: ≥25mm
  • Can be connected to the exit button

Three control modes:

  1. Inching mode:turn on after fingerprint recognition; automatically turn off after releasing the finger and reaching the set delay time.
  2. Self-locking mode:turn on after recognizing the fingerprint; after releasing the finger, it will be disconnected immediately after re-identifying the fingerprint.
  3. Ignition mode:keep the fingerprint recognition unreleased; it will keep on all the time, and it will disconnect immediately after releasing the finger

 LED Legend (Fingerprint Module)

  • Green = Action succeeded (enrolled / deleted / verified)
  • Red = Failed verification
  • Yellow = Add admin fingerprint mode
  • Pink = Add regular (user) fingerprint mode
  • Flashing Yellow = Delete a single admin fingerprint
  • Flashing Pink = Delete a single regular fingerprint
  • Flashing White = Delete all regular fingerprints (admins remain)
  • Blue (panel LED) = Relay control mode indicator

Relay Control Modes (Panel Blue LED)

  • 1 flash = Self-locking (toggle)
  • 2 flashes = Jog (timed pulse)
  • 3 flashes = Ignition (hold)
  • Jog-Mode Delay (Red LED Blink Count → Time) 

To adjust:

  1. Power OFF the board.
  2. Hold SET button.
  3. Power ON while holding SET.
  4. Release SET when panel red + blue LEDs turn off.
  5. Short-press SET to cycle delay (red LED blink count = time):
    1 =300 ms
    2 =600 ms
    3 =1s
    4 =2s
    5 =3s
    6 =4s
    7 =5s
    8 =10 s
    9 =60 s
    10 = 15 min
  6. Save by touching a valid fingerprint or card.

 Fingerprint Management (Admin Finger Required)

  • Add admin fingerprint: From factory: touch any finger ∼5 s → Yellow →
    press/release same finger 4–6 times until Green.
  • Add user fingerprint: Hold admin finger ∼10 s → Pink → release; press user finger (Blue then Green).
  • Delete a single admin fingerprint: Hold admin finger until Flashing Yellow →
     release; touch admin finger to delete (Green).
  • Delete a single regular fingerprint: Hold admin finger until Flashing Pink →
     release; touch user finger to delete (Green).
  • Delete all regular fingerprints (admins remain): Hold admin finger until Flashing White → release; confirm to wipe all regulars.
  • Factory reset (everything): Power ON, hold SET >10 s until panel red LED +
     module white LED → release.

Demo Mode (Important)

  • After deleting all fingerprints, the device enters a demo mode:
  • Any fingerprint will open the relay.
  • The module still flashes Red to indicate it is not a stored fingerprint.
  • This continues until at least one admin fingerprint is enrolled.
     

Card / NFC Management

  • First card after reset = Admin card.
  • Add user cards: admin card ∼5 s → beeps → present user cards.
  • Delete one card: admin card ∼10 s → beeps → present card to delete.
  • Delete all cards: admin card ∼15 s → beeps → all cleared.