Robot Pi Shop

Seat Pressure Sensor

$9.99

Shipping calculated at checkout.

Quantity

Seat Pressure Sensor – Thin Film Occupancy Detection Switch

The Seat Pressure Sensor is a thin-film pressure-activated switch designed to detect whether a person is sitting on a seat. Its flexible, low-profile design allows it to be installed beneath seat cushions for occupancy detection, monitoring, and automated control applications.

The sensor changes its electrical contact state when sufficient pressure is applied, making it suitable for seat occupancy detection systems, smart furniture, and electronic monitoring projects.

Key Features

  • Pressure-Activated Detection: Detects applied force through a change in electrical contact state.
  • Thin-Film Design: Suitable for installation beneath seat cushions and upholstery.
  • Wide Operating Temperature Range: Designed for operation from -40°C to +85°C.
  • Fast Response: Listed response time of approximately 6ms.
  • Low-Power Switching: Can be integrated into compatible low-voltage electronic monitoring circuits.
  • Flexible Installation: Suitable for seat occupancy detection and pressure-triggered applications.
  • Microcontroller Integration: Can be connected to Arduino, ESP32, and Raspberry Pi GPIO circuits using appropriate interfacing.

Technical Specifications

Parameter Specification
Product Type Seat Pressure Sensor / Thin-Film Switch
Sensor Function Pressure-Activated Contact
Material ABS (listed)
Maximum Switching Voltage 250V (listed; not independently verified)
Maximum Switching Current 100mA (listed; not independently verified)
Dielectric Withstand Voltage 2kV DC (listed)
Response Time 6ms
Contact Resistance 0.5–10Ω (listed)
Insulation Resistance 100MΩ (listed)
Operating Force 15–750g (listed)
Operating Temperature -40°C to +85°C
Cable Length Approximately 30.7 inches (78cm), as shown

Working Principle

The sensor operates as a pressure-sensitive electrical switch.

  1. No Pressure Applied: The switch remains open, with resistance greater than 10MΩ.
  2. Pressure Applied: The switch closes when sufficient force is applied, allowing electrical continuity.
  3. Pressure Released: The switch returns to its normal state when the applied force is removed.

The sensor provides a switching signal rather than a calibrated analog measurement of weight or pressure.

Connection with Arduino, ESP32, or Raspberry Pi

For a basic low-voltage occupancy detection circuit:

Sensor Connection Connection
Sensor Wire 1 Digital GPIO Input
Sensor Wire 2 GND
GPIO Configuration Input with Pull-Up Resistor
No Pressure HIGH (open contact)
Pressure Applied LOW (closed contact)

Note: This connection assumes a normally open sensor. Verify the actual switching behavior before installation. Use the appropriate 3.3V or 5V GPIO logic level for the controller.

Applications

  • Vehicle Seat Occupancy Detection
  • Smart Chair and Furniture Projects
  • Seat Presence Monitoring
  • Industrial Seating Systems
  • Pressure-Activated Switching
  • Arduino and ESP32 Projects
  • Robotics and Automation Systems
  • DIY Occupancy Detection Projects

Important Notes

  • This sensor is designed for occupancy detection, not precise weight measurement.
  • The listed voltage and current ratings require verification before use.
  • For Arduino, ESP32, and Raspberry Pi applications, use a suitable low-voltage GPIO circuit.
  • Avoid sharp bends, punctures, or excessive mechanical stress on the sensing elements.
  • Do not use this sensor as a replacement for certified automotive airbag or safety-critical occupancy detection systems.
  • The operating force specification should be verified for the intended installation.

Package Includes

    • 1 × Seat Pressure Sensor with Attached Cable